Energizer 515 Guia do Utilizador descarregar pdf (Página 67)

50 Chapter: 4

5 Press ESC. Your manual prime is complete.

6 You can now insert the infusion set into your body as described in the next section.

Insert the infusion set

After you complete all of the following, you will be ready to insert the infusion set into your body:

➠ fill your reservoir

➠ rewind your pump

➠ Insert the reservoir into pump

➠ and prime the pump (fill the infusion set with insulin)

It is important that you change your infusion set every 2-3 days. Medtronic MiniMed offers a number

of different infusion sets for your pump. Instructions for the Quick-set

begin on the next page as an

example. Always refer to the instructions that shipped with your infusion set. After your infusion set is

inserted, continue to the section “Fixed prime” on page 54.

If your manual prime uses more than 30U insulin, the pump will ask you, “is

priming complete?” If you get this message, do these steps:

a. Make sure you are not connected to the pump.

b. Read the message on the screen, then press ESC, ACT to clear.

a. If your manual prime is complete (you see droplets on the tip of the

infusion set needle), press ESC and continue to step 5. If your manual

prime is not complete, press and hold ACT until priming is complete then

continue to step 5.

WARNING: While the infusion set is connected to your body, do not unscrew and

retighten the tubing connector on the reservoir.

IS PRIMING

COMPLETE?

Disconnect from body

See user guide

for instruction.

ESC, ACT to clear

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 183 184

Sem comentários

Energizer 515 Guia do Utilizador Página 67